The M2000 is Adaptronic's base-level modular ECU. Continuing from where the 420d and 440 Select ECU's left off, the new industry-changing modular platform allows the owner to expand their ECU as and when required. It means that you need only buy the hardware that you need. For example, for an otherwise simple application which need drive-by-wire control you can use an M2000 ECU with optional DBW control module. The M2000 will accept any one of the single 'small' upgrade boards listed further down this page.
- The M2000 comes supplied with the following features and I/O: 2x On-board 4 bar MAP sensors. (1x inlet and 1x exhaust manifold pressure) 11x Analogue 0-5v inputs (2xTPS, 6x pressure inputs) 2x Analogue lambda sensor inputs 4x Temperature inputs (Coolant, air, oil, etc.) 3x Trigger inputs (Crank & Cam. Inbuilt ECU oscilloscope) 1x Vehicle speed input 1x Knock input 1x On-board 3 axis accelerometer 1x On-board 3 axis rate gyro 2x Dedicated fuel pump and EFI relay outputs 1x Headphone output for knock monitoring 1x CAN channel (Up to 1Mbps - internal switchable termination) 1x USB port (12Mbps - no drivers necessary) 4x RS232 Serial channels (For connection to instruments, wideband controllers, etc.) 1x Wireless connection (Access point, 230kbps, for transfer of settings and live data) The ECU has 32MB of on-board ram for internal data logging. 30hrs @ 10Hz, 13 channels or 20 minutes at 100 Hz, 125 channels. Main outputs: 8x Injector outputs (Low or high impedance) 8x Ignition outputs (low current. Unused channels can be set as aux. outputs, PWM capable) 4x Aux outputs (Push-Pull - can drive high or low. 4A max. PWM capable) Further to the above the ECU can be expanded with a 'small' output board, giving a further 6x aux outputs capable of 1.2A high-side or 4A low-side. PWM capable. The EUGENE software is a free download (available at www.adaptronic.com.au)